Home » Store » Dell » Dell Misc » 374-BBHM: Dell Standard heatsink for PowerEdge R730 and R730xd

374-BBHM: Dell Standard heatsink for PowerEdge R730 and R730xd

Dell Standard heatsink for PowerEdge R730 and R730xd. Part number 374-BBHM.

Built for end users, business partners, government agencies, and contractors, we replace auction-site guesswork with direct human support. You get dedicated specialists who answer the phone, confirm exact compatibility, and deliver project-ready pricing built around your deployment timeline.

Home / Shop

374-BBHM: Dell Standard heatsink for PowerEdge R730 and R730xd
374-BBHM: Dell Standard heatsink for PowerEdge R730 and R730xd
374-BBHM: Dell Standard heatsink for PowerEdge R730 and R730xd

Home / Shop

374-BBHM: Dell Standard heatsink for PowerEdge R730 and R730xd

Model Number: 374-BBHM
Dell Standard heatsink for PowerEdge R730 and R730xd. Part number 374-BBHM.
Maximum quantity exceeded
Minimum purchase amount of 0 is required
Maximum purchase amount of 0 is allowed
Missing Inquiry Options
*Your Name:
*Your Email:
*Your Message:
Please send me a copy
0.000
Categories: Dell Misc
Manufacturer: Dell
Facebook
X
Email
LinkedIn
  • Description
  • Specifications

The 374-BBHM Dell Standard heatsink for PowerEdge R730 and R730xd cools the processor in a PowerEdge R730, which takes one or two Intel Xeon E5-2600 v3 or v4 processors. Each heat sink is held to the system board by four retention screws. The R730 also has a separate 165 W heat sink for the Intel Xeon E5-2689 v4, and GPU installations use a low-profile heat sink from the GPU enablement kit.

The heat sink is what keeps the processor within its thermal limits, so Dell warns against taking it off unless the processor itself is being removed. It stays hot for a while after power-down. To release it, use a Phillips #2 screwdriver: loosen one screw, wait roughly 30 seconds for the heat sink to free itself from the processor, then remove the diagonally opposite screw and the other two. The cooling shroud comes off first, and any full-length PCIe cards are removed to reach it.

When the heat sink goes back on, old thermal grease is wiped off with a lint-free cloth and fresh grease from the syringe in the processor kit is applied in a thin spiral on top of the processor. The syringe is single-use, and too much grease can contaminate the processor socket. The heat sink is placed on the processor and the four screws are tightened one after another. It is fitted after the processor, and an empty processor socket takes a processor blank.

374-BBHM Specs 
ProductDell Standard heatsink for PowerEdge R730 and R730xd
Fitted inPowerEdge R730
Supported processorsIntel Xeon E5-2600 v3 or v4 family, up to two
RetentionFour screws to the system board
ToolPhillips #2 screwdriver
Thermal pasteReapplied on installation, single-use syringe in the processor kit
Other R730 heat sinks165 W heat sink for Intel Xeon E5-2689 v4; GPU kit low-profile heat sink
AccessRemove cooling shroud and full-length PCIe cards first