Home / Shop


- Description
- Specifications
311-6199 is the Dell 16GB (8x2GB) 667MHz dual ranked DIMM memory kit for PowerEdge 2950. The PowerEdge 2950 uses fully buffered (FB) DDR II memory modules in 533 MHz or 667 MHz speeds, installed in eight sockets on the system board under the cooling shroud. The sockets form two branches of two channels each, and each channel holds two DIMMs: channel 0 has DIMM_1 and DIMM_5, channel 1 has DIMM_2 and DIMM_6, channel 2 has DIMM_3 and DIMM_7 and channel 3 has DIMM_4 and DIMM_8. The first socket of each channel has white release tabs.
Modules must be qualified fully buffered DIMMs, either single-ranked (marked 1R) or dual-ranked (marked 2R). A minimum of two identical modules is needed, sockets are populated lowest number first, and modules go in pairs matched for size, speed and technology, with two, four or eight in total. For best performance all four or all eight should be identical. A set of eight 2 GB dual-rank modules fills every socket.
With eight identical modules installed the system supports memory sparing, which allocates the first rank of the DIMMs in sockets 1 to 4 as the spare bank. With eight 2 GB dual-rank modules 16 GB is installed, 12 GB is available and 4 GB is held as spare. Memory mirroring also needs eight identical modules, and the available memory is then one-half of the installed memory. Sparing and mirroring cannot run at the same time, and both are enabled in the System Setup program.
| 311-6199 Specs | |
| Product | 16GB (8 x 2GB) DIMM kit for PowerEdge 2950 |
| Module type | fully buffered DDR II (FB-DIMM) |
| Speed | 667 MHz (system takes 533 or 667 MHz) |
| Rank | dual rank (2R) |
| Module size | 2 GB |
| Sockets in system | 8 (4 channels, 2 DIMMs each) |
| Install rule | matched pairs; 2, 4 or 8 modules |
| Sparing and mirroring | need 8 identical modules |
| Sparing with 8 x 2 GB dual-rank | 12 GB available, 4 GB spare |
