Home / Shop


- Description
- Specifications
The 374-BBHM Dell Standard heatsink for PowerEdge R730 and R730xd cools the processor in a PowerEdge R730, which takes one or two Intel Xeon E5-2600 v3 or v4 processors. Each heat sink is held to the system board by four retention screws. The R730 also has a separate 165 W heat sink for the Intel Xeon E5-2689 v4, and GPU installations use a low-profile heat sink from the GPU enablement kit.
The heat sink is what keeps the processor within its thermal limits, so Dell warns against taking it off unless the processor itself is being removed. It stays hot for a while after power-down. To release it, use a Phillips #2 screwdriver: loosen one screw, wait roughly 30 seconds for the heat sink to free itself from the processor, then remove the diagonally opposite screw and the other two. The cooling shroud comes off first, and any full-length PCIe cards are removed to reach it.
When the heat sink goes back on, old thermal grease is wiped off with a lint-free cloth and fresh grease from the syringe in the processor kit is applied in a thin spiral on top of the processor. The syringe is single-use, and too much grease can contaminate the processor socket. The heat sink is placed on the processor and the four screws are tightened one after another. It is fitted after the processor, and an empty processor socket takes a processor blank.
| 374-BBHM Specs | |
| Product | Dell Standard heatsink for PowerEdge R730 and R730xd |
| Fitted in | PowerEdge R730 |
| Supported processors | Intel Xeon E5-2600 v3 or v4 family, up to two |
| Retention | Four screws to the system board |
| Tool | Phillips #2 screwdriver |
| Thermal paste | Reapplied on installation, single-use syringe in the processor kit |
| Other R730 heat sinks | 165 W heat sink for Intel Xeon E5-2689 v4; GPU kit low-profile heat sink |
| Access | Remove cooling shroud and full-length PCIe cards first |
