Home / Shop
- Description
- Specifications
The 331-4508 Dell Heat sink for PowerEdge R720 and R720xd sits on a processor in both the R720 and the R720xd, where there is one heat sink for processor 1 and another for processor 2. Each is secured by two retention screws. The R720 takes one or two Intel Xeon E5-2600 or E5-2600 v2 processors, and a single processor goes in socket CPU1. A processor blank, or a heat-sink blank, fills any empty position so cooling stays correct.
Dell warns that the heat sink must not be removed from a processor unless the processor itself is coming out, because the heat sink maintains the thermal conditions the processor needs. Both parts stay hot after power-down. After the cooling shroud is off, loosen one retention screw with a Phillips #2 screwdriver, wait 30 seconds for the heat sink to release from the processor, loosen the second screw and lift the heat sink away.
On installation the old thermal grease is wiped from the heat sink with a lint-free cloth, and all the grease in the applicator from the processor kit goes on the center of the top of the new processor. The heat sink is set on the processor, the two retention screws are tightened, and the cooling shroud goes back. A thermal-trip message on the LCD, reading CPU number has a thermal trip, check CPU heat sink, calls for a check of the logs for fan failures and then a reinstall of the processor heat sink. GPU installations in the R720 use low-profile heat sinks from the GPU enablement kit instead.
| 331-4508 Specs | |
| Product | Dell Heat sink for PowerEdge R720 and R720xd |
| Fitted in | PowerEdge R720 and R720xd |
| Heat sinks per system | One per processor, two in a two-processor system |
| Retention | Two screws per heat sink |
| Tool | Phillips #2 screwdriver |
| Supported processors (R720) | One or two Intel Xeon E5-2600 or E5-2600 v2 |
| Thermal paste | Applicator from the processor kit, wiped and reapplied on installation |
| GPU installations | Low-profile heat sinks from the GPU enablement kit |
| Release wait | 30 seconds after loosening first screw |

