CP-7800-WMK Cisco IP Phone 7800 Series Wall Mount Kit

CP-7800-WMK is the Cisco wall mount kit for the IP Phone 7800 Series, and the spare form is CP-7800-WMK=. It is made for the Cisco IP Phone 7821 and 7841, and each Cisco phone wall mount is unique to its phone model, so this kit cannot be used with another model.

The kit holds one phone bracket, one wall bracket, four M8-18 x 1.25-inch Phillips-head screws, four anchors, two M2.5 x 6-mm machine screws and one 6-inch Ethernet cable. The screws and anchors are meant for drywall; other wall surfaces need suitable screws and anchors of their own.

Mounting starts with the wall bracket, held level with its arrow pointing up. Mark the holes, set the anchors and screw the bracket to the wall, using a #2 Phillips screwdriver, a level and a pencil. The phone bracket then hooks into the mounting tabs on the back of the phone and is secured with the machine screws, using a #1 Phillips screwdriver.

The Ethernet cable runs from the phone network port to the wall jack, while the PC port, power cord and in-bracket jack connections are optional. The phone slides onto the wall bracket by its top tabs and clicks into place. To remove it, insert a tool into the holes in the phone mounting plate to release the two locking tabs and lift the phone off. A working Ethernet connection should be close by, and the connector must sit flush or recessed in the wall if the phone covers it.

The phone bracket carries the weight of the phone, so it must be attached securely. A wall-mounted phone may also need its handset rest tab adjusted so the handset stays in the cradle.