Home / Shop
- Description
- Specifications
AB551A is an ATI Radeon 7500 PCI graphics controller with 64 MB of DDR SDRAM. It is a single-slot, 32-bit, 66/33 MHz universal PCI card based on the ATI RV200 chip, with a 350 MHz RAMDAC. It provides 2D and 3D acceleration on HP OpenVMS I64 and 2D on supported HP-UX systems. The kit carries the graphics controller and an installation sheet, AB551-90001. The board spare is 30-10119-02.
The card has a standard 15-pin VGA connector, a DVI-I connector and an S-Video connector, though S-Video does not work under OpenVMS I64 or HP-UX. There is no VGA switch, since the console firmware and software configure VGA automatically. HP-UX handles every video connection, including direct DVI to DVI, DVI to analog and VGA to VGA. OpenVMS I64 uses DVI only through a DVI-to-analog adapter or cable, drives both outputs with one image, and defaults to 1024x768 at 70 Hz and 24 bits per pixel.
On HP-UX the default is 1280x1024 at 75 Hz, changed through sam before HP-UX 11.31 or smh from 11.31 onward, and checked with /opt/graphics/common/bin/setmon -p. Several cards provide multihead desktops: each device appears as /dev/gvid0, /dev/gvid1 and so on, and the XF86Config ServerLayout, Screen and Device sections can map two or three screens across two cards. HP-UX 11i v3 is covered by the smh route.
The AB290A card is not supported together with an AB551A on a shared rope on the rx3600 and rx6600. The HP 9000 rp3410 and the HP Integrity rx1620 and rx2600 use AB551A.
| Designation | AB551A |
| Manufacturer | HPE |
| Type | PCI graphics controller |
| Chip | ATI RV200 (Radeon 7500) |
| Memory | 64 MB DDR SDRAM |
| Bus | 32-bit, 66/33 MHz universal PCI |
| RAMDAC | 350 MHz |
| Connectors | 15-pin VGA, DVI-I, S-Video |
| Operating system | HP-UX (2D), OpenVMS I64 (2D and 3D) |
| HP-UX default mode | 1280x1024 at 75 Hz |
| Spare | 30-10119-02 |

