Home / Shop


- Description
- Specifications
AD393A is a PCIe combination card with two fully independent 1/2/4 Gb Fibre Channel ports and two fibre 1000Base-SX Gigabit Ethernet ports, all on LC connectors. It takes one full-height, half-length x8 PCIe slot and meets PCIe Base Specification 1.0a or later. The Fibre Channel half uses the same protocol and driver as the AD355A and AD299A 4 Gbit cards, and the Ethernet half the same as the AD337A, AD338A and AD339A cards. Spare boards are AD393-67001, AD393-67102 and AD393-67103.
The card runs HP-UX 11i v3 on specified Integrity servers with two drivers from the March 2008 release: fclp in the FibrChanl-02 bundle and iether in IEther-00 (both B.11.31.0803 or later). Serviceguard, Ignite-UX and vPars 5.03 or later are supported. PCIe online addition and replacement works on specified systems, but not in the shared slots 3 and 4 of the rx3600 and rx6600, and online deletion is not available on the first release. The card-resident EFI uses Fibre Channel driver 3.21a3 or later with ISP firmware 2.72a2, and Gigabit Ethernet driver 3.2.06 or later.
Fibre Channel provides boot and dump support, automatic speed sensing to 1, 2 or 4 Gb/s, automatic topology detection and the SCSI-FCP, FC-FS, FC-PH-2, FC-PH-3, FC-TAPE, FC-PLDA, FC-AL-2, FCP-2 and FC-GS-3 protocols over arbitrated loop, point-to-point and switched topologies. Gigabit Ethernet provides jumbo frames from 1501 to 9000 bytes, VLANs, Auto-Port Aggregation, checksum offload, TCP segmentation offload and LAN boot. 1000Base-SX reach on 50 micron fibre is 2 to 66 m at 400 MHz*km, 2 to 82 m at 500 MHz*km and 2 to 300 m at 2000 MHz*km.
LC-LC cables are 221692-B21 (2 m), B22 (5 m), B23 (15 m), B26 (30 m) and B27 (50 m). The MAC address on the card is for LAN port A, and 0x1 is added for port B; the printed WWN is for Fibre Channel port 1, and 0x2 is added for port 2. HP advises moving AD393A to firmware 2.82X4 SLI-3 where 2.70X5 runs on a private loop. The HP Integrity rx3600 and rx6600 use AD393A in their PCIe slots.
| Designation | AD393A |
| Manufacturer | HPE |
| Type | Fibre Channel and Gigabit Ethernet combination card |
| Fibre Channel | 2 ports, 1/2/4 Gb/s |
| Ethernet | 2 ports, 1000Base-SX |
| Connectors | LC |
| Bus | PCIe x8, full height, half length |
| Operating system | HP-UX 11i v3 |
| Drivers | fclp (FibrChanl-02), iether (IEther-00) |
| Jumbo frame MTU | 1501 to 9000 bytes |
| Spares | AD393-67001, AD393-67102, AD393-67103 |
