Home / Shop
- Description
- Specifications
The AIR-ANT2410Y-R is a Cisco Aironet Yagi antenna for 2.4 GHz with 10 dBi of gain, an enclosed six-element directional array. The 3-dB beamwidth is 55 degrees in both the horizontal and vertical planes across 2400 to 2485 MHz, front-to-back ratio is 23 dB, the maximum side lobe level is below -16 dB, and VSWR stays under 1.5:1 at a nominal 50 ohms.
A 3 ft (0.91 m) low-loss RG-58 lead ends in an RP-TNC plug, and the mating connector is an RP-TNC jack. The housing is 3 in. (7.6 cm) in diameter with a wind rating of 125 mph (201.2 km/h), and it goes indoors or outdoors. On a mast it uses two V blocks, two U bolts and four 5/16-18 nuts with washers; wall mounting works on a smooth flat surface, with no hardware supplied. Polarization ships vertical, and rotating the antenna on its base switches it to horizontal.
It works with Cisco Aironet access points and bridges and with any 2.4-GHz Cisco Aironet radio device that has an RP-TNC connector. For FCC RF exposure limits, keep it at least 7.9 in. (20 cm) from people. Cisco recommends a low-loss cable kept as short as possible, as loss grows with cable length. Related antennas and accessories are in Cisco wireless.
| Part number | AIR-ANT2410Y-R |
| Antenna type | Yagi, enclosed six-element |
| Frequency range | 2400-2485 MHz |
| Gain | 10 dBi |
| Nominal input impedance | 50 ohms |
| VSWR | Under 1.5:1 |
| Polarization | Linear, vertical or horizontal |
| 3-dB beamwidth | 55 degrees horizontal, 55 degrees vertical |
| Front-to-back ratio | 23 dB |
| Cable | 3 ft (0.91 m) low-loss RG-58 |
| Connector | RP-TNC |
| Diameter | 3 in. (7.6 cm) |
| Wind rating | 125 mph (201.2 km/h) |
| Mounting | Mast or wall |
| Environment | Indoor and outdoor |
| Compatible with | Cisco Aironet access points and bridges and any 2.4 GHz Cisco Aironet radio device with an RP-TNC connector |